Post by vexxcapez on Mar 5, 2012 0:58:37 GMT -5
Well, since I didnt get any response on my truck, I figured I would add some stuff here.
This is my 1963 MG Midget, it has a 350 small block engine, 4:10 gears, Hooker Headers ported and polished, Edelbrock valve covers, Magnum 280 HR Roller Cam, Comp roller rockers, MSD Ignition and timing, Blower, wheelie bars on the backside. Backwheels are 15 x 12. I also have Nitrous Oxide installed
These pictures were taken at my buddies shop where me and my father in law are building this. Its a 1929 Model A Coupe, all we had was the body itself. We have built the frame out of tubular steel and cambered the body three inches down the frame, which means the body sits lower then the frame of the car itself. Since these pictures we have added corvette valve covers, aluminum headers, the engine and tranny have been fully mocked up. It sits on 15x18 inch back tires, and we have ordered two turbo chargers that will be mounted along either side of the engine. I will keep posting pictures as we go. We are going to chop the top of the roof by 5 inches so that it is lowered as well. This will be a 350 big block once completed, but right now it is still in its baby stages.
And for all of you that didnt see, this is my daily driver. My first baby.
This is my 1963 MG Midget, it has a 350 small block engine, 4:10 gears, Hooker Headers ported and polished, Edelbrock valve covers, Magnum 280 HR Roller Cam, Comp roller rockers, MSD Ignition and timing, Blower, wheelie bars on the backside. Backwheels are 15 x 12. I also have Nitrous Oxide installed
These pictures were taken at my buddies shop where me and my father in law are building this. Its a 1929 Model A Coupe, all we had was the body itself. We have built the frame out of tubular steel and cambered the body three inches down the frame, which means the body sits lower then the frame of the car itself. Since these pictures we have added corvette valve covers, aluminum headers, the engine and tranny have been fully mocked up. It sits on 15x18 inch back tires, and we have ordered two turbo chargers that will be mounted along either side of the engine. I will keep posting pictures as we go. We are going to chop the top of the roof by 5 inches so that it is lowered as well. This will be a 350 big block once completed, but right now it is still in its baby stages.
And for all of you that didnt see, this is my daily driver. My first baby.
